Whenever we talk about any place or machinery that deals with heavy loads safety parameters are very important to consider. This is because a little carelessness could result in a big mishap at such locations. Hence, it always advised performing all the checks and inspections before this machinery is put to use.
The same applies to beam clamps. Beam clamps have made the process of lifting and handling heavy loads easier. This has increased their use considerably. And, so comes attached is the safety tips that must always be followed.
Before the operator uses the beam clamps, it should be ensured that all the inspections are performed and the clamps are good to use. So, let us know about the important inspection to be performed by the leading beam clamps manufacturers:
Ensure Clamp & Beam Size are Compatible:
Before the beam clamps are put to use one must ensure that the clamp size and beam size are compatible to be used together. This is to ensure that whether the clamp size is good to hold the beam.
This is very important to ensure as incompatible sizes could result in drop leading to serious accidents at the worksite. Hence, an operator should always ensure that the beam and clamp size are good to be used together says leading lifting clamps manufacturers.
Check for Damage in Advance:
Often times accidents and mishaps occur because of the existing damage in the clamp. No one knows when the small damage could turn into a big accident. Hence, it is a good practice to check the beam well in advance for any damage or deterioration before it is put to use.
While checking one should take special care for attachment points as these are more prone to damage. This little check can prevent quite a bigger mishap hence, it must always be taken care of says leading beam clamp manufacturers.
This one is a basic check and should be performed not only for clamps but other mechanical devices as well as chain hoists and winches as suggested by electric wire rope hoist suppliers.
Ensure that Load Limits are Maintained:
One of the most important inspection steps that hold true for almost every lifting machinery is to maintain the load limits. The identification number and color code on the beam clamp says a lot about it, and so should be checked.
Also, the operator should ensure that the beam which is being clamped does not go beyond the maximum load limits of the clamp. It is better to do two safe rounds of lifting than doing one accidental. Hence, always ensure to obey the load limits.
Besides, one should take care of other little things that include checking the handle of the clamp, checking the screws, and the screw thread etc.
With these inspection tips, we wish you efficient handling of the beam clamp. If you want to grab more information feel free to connect us.