Beam clamps are widely used in several industries in different kinds of types of machinery. It is important that the clamp should be strong and durable. It is also important to ensure that beam clamp is being used considering all the safety parameters.
A little ignorance might lead to an uninvited mishap at the worksite. Hence, safe use of beam clamp is extremely necessary. All the safety instructions should be followed and proper maintenance check of the clamp should be carried out before its use.
So, let us have a look at the list of dos and don’ts regarding the use of beam clamps by leading beam clamp manufacturers:
Do’s:
Proper Use & Handling:
It is very important that the beam clamp must be properly used and handled. Many times, accidents or mishaps occur because the clamp was not put to its appropriate use.
Hence, always ensure that the beam clamp is being used properly as instructed by the manufacturer.
Check the Support Load Limits:
It is very important to check is the support weight is less than the maximum load limit of the beam clamp says leading lifting clamp manufacturers. It is recommended to go for lesser weights for safety reasons.
Hence, do follow the same in your industry as well for safe handling of the clamp.
Check all the Fittings:
Another important measure to take care of is the checking of all the fittings in the clamp. Make sure that the support load is properly attached and all the nuts are fit appropriately.
Hence, before a beam clamp is being used do check all the fittings ensuring that no lose nuts are left behind in the clamp.
Don’ts:
Use of Uncertified Beam Clamps:
Always use properly identified and certified beam clamps. There are some suppliers who would try to sell uncertified clamps at cheaper rates. Never fall for the low cost as it might cost you significantly larger in the later stages.
So, always ensure that uncertified or unidentified beam clamps are not being used in your industry says leading beam clamp manufacturers.
Bolt Replacement without Supplier’s Consent:
Never try to repair beam clamp by changing the fittings or nuts on own without the consent of the manufacturer from which it is purchased. With any clamp, there always comes a proper set of steps to be followed for refitting.
And, it is extremely important that the same shall be followed. Hence, never try to change any kind of fittings without the consent of the supplier.
Dropping of Beam Clamps:
Avoid dropping of beam clamps and ensure that these are properly kept when not in use. Their improper placement will lead to their quality degradation which cost you later.
Hence, better be safe from it and ensure that the clamps are properly kept and stored.
With this list of do’s and don’ts ensure that beam clamps are being properly used in your industry. To know more about clamps, winches and cranes feel free to contact us anytime.